View Full Version : Engine Bay

07-03-2011, 01:16 PM
I pulled the over off my engine the other day to gain easier access to the grommet to run the amp wires and noticed that it was extremely dirty and greasy my question is what is the best way to clean up the top of my engine can I just blast it with a hose or will that do damage?? any help


07-03-2011, 04:57 PM
I have used rags and a mild detergent in the past. If the detergent is not strong enough you could spray some degreeser onto a rag but be carefull of the plastic bits, the degreeser may have a negative effect on them.
Bottom line...do it by hand, the slow safe way :)

07-03-2011, 06:05 PM
blasting it with a hose will only get water in those expensive electrical components and you wii be stuffed...as dgp said a small spray can of degreaser and slowly by hand is the best way

09-03-2011, 10:17 AM
thanks guys guess I know what ill be doing this weekend